Once again things got busy yesterday evening and I neglected to post the daily notes, so this is for yesterday, Monday the 5th.
The morning session was spent surface planning the 4 half-panels we glued up last week to 3/8" thick, jointing the inner edges and gluing them into full panels for use in the case sides. Then we set up the tools to cut tenons.
The afternoon session was used to cut tenon shoulders on the band saw, then cut the tenon cheeks on the table saw using a tenoning jig.
I had a little time left over so I went ahead and laid out the mortise locations on the back panel stiles and set up the drill press with the mortising attachment so it will be ready to use in the morning.
'Nuff for today, see you tomorrow.
_____
avast! Antivirus <http://www.avast.com> : Outbound message clean.
Virus Database (VPS): 0623-0, 06/05/2006 Tested on: 6/6/2006 9:01:29 AM avast! - copyright (c) 1988-2006 ALWIL Software.
No comments:
Post a Comment
Appropriate comments are welcome. All comments are reviewed before being posted. Spam messages (anything not a direct discussion of this message) and all profanity will be deleted. Don't waste your time or mine by posting trash here.